Use a hand held wire brush and use small circular motions after you pull off the fabric. Do not push hard and watch you do not get into fiberglass. Works great. I have personally done this twice.
Thanks Jerry. I will figure the rest out. I started in the back today and as I suspected I have to manufacture fuel tank strap supports. One good and one gone. Just going to fig for both. My K member I took it completely apart and put in all new bushings and ball joints. I have the K member put back on the car but still need to get all the other parts on. I have a post I started but have not updated as progress is very very slow going. I will try to get some pics and get them on.
Jerry, Can you get a measurement on how far the rack sleeves stick out on th K member?? I am going to have to fabricate some as I checked with Ford and there are no kits or parts avaiable. Thanks in advance and your are doing an awesome job. Keep it up.
Would this be the same if your wipers were frozen in place and then suddenly let go. They now are not going to the home position. Work fine other wise.
Seller expects pay in resonable time. Why should I as the buyer expect different. I had a similar issue but did not post negative. Seller took on new job and was unable to ship. Took over 2 months. Seller never contacted me to what was going on. These things are not right. If you sell be prepared to ship promtly upon reciept of payment.