no spark from coil

Topic: no spark from coil (Read 1171 times) previous topic - next topic

no spark from coil

September 22, 2005, 07:00:50 PM

i have changed the comp, coil, ing mod. still have nothing. also checked voltage at coil and that was good. please help.

Re: no spark from coil

Reply #1 – September 22, 2005, 07:52:18 PM

Take your distributor cap off, have somebody crank the engine, and verify that the rotor is turning. You may have broken a timing belt, and if so you'll have no spark because the distributor won't turn

Re: no spark from coil

Reply #2 – September 22, 2005, 08:40:18 PM

i dont have a spark leaving coil, timing belt is ok.

Re: no spark from coil

Reply #3 – September 22, 2005, 10:15:03 PM

Quote from: tbirb23l

i dont have a spark leaving coil, timing belt is ok.

ok since you said timing belt i am assuming it is a 2300 turbo

they are bad about eating distributor gears pull the cap off and make shure the rotor turns.

then take a test light and put it in the positive side of the coil (orange or red wire) turn switch over it should light the test light if it does you have a tfi problem possible wiring

Re: no spark from coil

Reply #4 – September 22, 2005, 10:33:48 PM

yes it is 2.3l. i do have voltage at postive term. on coil. 9.87volts at coil. i also changed the dist.

Re: no spark from coil

Reply #5 – September 22, 2005, 11:12:13 PM

Quote from: tbirb23l

yes it is 2.3l. i do have voltage at postive term. on coil. 9.87volts at coil. i also changed the dist.

it should have a full 12v at the coil

sounds like a wiring issue that you have. between the tfi module and the computer

Re: no spark from coil

Reply #6 – September 22, 2005, 11:25:44 PM

i will check that. thanks. will check in fri.

Re: no spark from coil

Reply #7 – September 24, 2005, 12:39:08 PM

Quote from: tbirb23l

i will check that. thanks. will check in fri.

any luck?