Can anyone help me ID this? Reply #1 – July 04, 2018, 04:59:40 PM 1986 Turbo Coupe. Came out of blower housing. Blower was working before I removed this part. when reinstalled blower no longer works, one wire carries 5.3 volts when ignition on. Quote Selected
Can anyone help me ID this? Reply #2 – July 04, 2018, 06:30:29 PM Looks like a blower motor resister, usually in charge of controlling desired fan speeds Quote Selected
Can anyone help me ID this? Reply #3 – July 04, 2018, 09:23:28 PM Should work on high if that's the problem. Quote Selected
Can anyone help me ID this? Reply #4 – July 05, 2018, 09:50:44 AM Too small of a resistor for a blower motor. Looks more like a resistor across a thermistor, AKA temperature sensor. Is this for a car with automatic/digital temperature controls? Quote Selected
Can anyone help me ID this? Reply #5 – July 05, 2018, 01:11:12 PM Quote from: CoogarXR;466330Too small of a resistor for a blower motor. Looks more like a resistor across a thermistor, AKA temperature sensor. Is this for a car with automatic/digital temperature controls?That Is what I have. Think it's called "automatic temperature control". Do you know if the blower would run or not, if this component is defective? I did not get any failure codes. All fuses are good.Thanks for your help. Quote Selected
Can anyone help me ID this? Reply #6 – July 06, 2018, 02:04:23 PM I have owned a couple cougars with ATC, but I have never had to work on the system. Most of my fox bodies have had the manual setup.Many members on here are knowledgeable with the ATC system, and/or have the shop manuals and could probably tell you the function of that sensor. So while this post isn't helpful at all, it's a bump back to the top for ya. Quote Selected
Can anyone help me ID this? Reply #7 – July 07, 2018, 10:59:37 PM Try pulling codes as described in this coolcats write-up. http://www.coolcats.net/help/atc.html Quote Selected
Can anyone help me ID this? Reply #8 – July 08, 2018, 10:38:30 AM Quote from: softtouch;466360Try pulling codes as described in this coolcats write-up. http://www.coolcats.net/help/atc.htmlDid it. Code was 88 Quote Selected
Can anyone help me ID this? Reply #9 – July 08, 2018, 11:54:24 AM Now that I've had a morning to troubleshoot, here is where I am.Found the plug with the wires going to blower motor. confirmed different voltages for 3 fan speeds at power side of plug. Applies 12v and known good ground to load side of plug and fan does not run. Ohm meter confirms open. So I guess I'm going to be pulling the dash to get to the blower. I would like to thank all who replied. All opinions are appreciated. I have been looking around this site and forum. You people are awesome. The amount of information shared here is great. I will offer any info I can. A special thanks to all who contributed to the dash R&R procedure on this site. You make it look less intimidating. I will let you know how I make out. Quote Selected
Can anyone help me ID this? Reply #10 – July 09, 2018, 10:19:39 AM Glad you figured it out. Pulling the dash is more time consuming than hard. Just take your time, you'll do fine. Quote Selected
Topic: Can anyone help me ID this? (Read 2125 times)
previous topic - next topic
