Skip to main content ↑ ↓
Topic: 3 pod A pillar gauge question (Read 747 times) previous topic - next topic

3 pod A pillar gauge question

im buying a 94-98 3 Pod A pillar and im putting a boost gauge, A/F meter and Fuel pressure gauge. Does anybody else have a setup like this? how easy is it to install? I know the fuel pressure has to have a sending unit, where can i buy one from?
1987 turbo coupe 5speed: Boport stage 3 head/2.5 cam , Precision stage 3 50trim .63 turbo, Tial 38mm wastegate, Jangus gutted/ported intake manifolds, 60mm tb, Jangus open dumptube, Jangus 3" elbow, Perrin boost controller,Esslinger adjustable cam pulley, Esslinger small crank pulley, stinger FMI, RFL BOV, Spec stage 3 clutch, B&M short throw, 140 speedo, Walbo 255lph, BBK fpr, 3G alternator, ARP studs.  Be faster... :poke:

3 pod A pillar gauge question

Reply #1 –
For the boost gauge, where does the hose come from that runs to the stock boost gauge? i tried looking but once it goes into the firewall, well im not superman and i dont know what hose goes where. So i dont know what hose i have to replace with a longer one to run up to my boost gauge to one of the pods.
1987 turbo coupe 5speed: Boport stage 3 head/2.5 cam , Precision stage 3 50trim .63 turbo, Tial 38mm wastegate, Jangus gutted/ported intake manifolds, 60mm tb, Jangus open dumptube, Jangus 3" elbow, Perrin boost controller,Esslinger adjustable cam pulley, Esslinger small crank pulley, stinger FMI, RFL BOV, Spec stage 3 clutch, B&M short throw, 140 speedo, Walbo 255lph, BBK fpr, 3G alternator, ARP studs.  Be faster... :poke: