Question about rouge wire....

Topic: Question about rouge wire.... (Read 1122 times) previous topic - next topic

Question about rouge wire....

May 22, 2014, 02:33:05 AM

I'm wrapping up a GT-40 intake swap on my '88 Sport.

There is one wire that I am a little confused on where it goes. Its a single wire with a connector on the end that runs along the drivers side fuel injector loom and down the front of the engine behind the power steering pump. It came un-plugged while I was moving the wiring harness around and I can't seem to figure out where it goes.

I'll be able to take a picture of it in the light tomorrow but I was just curious if anyone knew where it went...

Question about rouge wire....

Reply #1 – May 22, 2014, 03:56:54 AM

Oil sending unit by the filter?

Question about rouge wire....

Reply #2 – May 22, 2014, 10:21:02 AM

oil sender is white red
low oil sensor is dark blue/light green
coolant temp sender is red/white

there is an unused single wire but two port connector near / within the hvac harness. this connector is very flat and about 3/16'' thick and about 5/8'' wide.

Question about rouge wire....

Reply #3 – May 22, 2014, 10:22:29 AM

double check all the vast amount of connectors along / downstream of the ignition coil and along the battery.

Question about rouge wire....

Reply #4 – May 22, 2014, 12:24:17 PM

Probably the oil pressure sender wire. If not it could be for the low oil level sender, if equipped.

Question about rouge wire....

Reply #5 – May 24, 2014, 01:15:18 AM

Yeah I got it, It was the sending unit wire. Thanks guys!