BlkBrd is breathing a little easier now!

Topic: BlkBrd is breathing a little easier now! (Read 861 times) previous topic - next topic

BlkBrd is breathing a little easier now!

February 21, 2013, 05:51:14 PM

When I bought my TC (BLKBRD) a couple of years ago it had a 3" crack that ran along the top of the cast-iron turbo exhaust elbow. Since the car already had a 3" down-pipe, and 2 1/2" dual catless exhaust to the rear bumper I wanted to do a more complete breathing fix when I repaired it.
I had a 3" steel tubing elbow fabricated and then a mechanic friend who is also a fabricator installed it. He cut pieces from a mandrel bent U and made two 45º bend pipes and used a flex pipe from Stinger to complete the installation. Below are the pics of the process:
****************************************
Steel elbow & new oxygen sensor installed

Flex pipe & first 45º piece installed

Buttoned up tight with the second 45º piece & a Stinger Clamp

BlkBrd is breathing a little easier now!

Reply #1 – February 22, 2013, 08:50:44 AM

Looks nice. Should flow pretty good.

BlkBrd is breathing a little easier now!

Reply #2 – February 22, 2013, 12:34:55 PM

Thats a good fab and should work just fine!!

BlkBrd is breathing a little easier now!

Reply #3 – February 23, 2013, 05:03:23 PM

For those interested, that IHI down elbow is a new build unit, not built using an old elbow. New laser cut , and aluminized mandrel bent elbow. Fabrication included the proper cut for the additional material to allow the flow from the wastegate port to enter the main tube. I wish I had remembered to take pics before I shipped it.

BlkBrd is breathing a little easier now!

Reply #4 – February 24, 2013, 12:38:41 PM

John, if I had known you wanted pics of it I could have snapped them prior to installation. It is a beautiful piece of work.......thanks
Ron