quick and easy, motor disassembly question September 01, 2009, 08:19:29 AM When taking the valvetrain out for a cam swap, do the pushrods, lifters and rocker arms have to go back in the same posistion/valve as they were prior? :hick: Quote Selected
quick and easy, motor disassembly question Reply #1 – September 01, 2009, 10:58:11 AM Yes. But, make sure there's no wear on either the pushrods or the lifters. You are talking stock replacement cam, right? Quote Selected
quick and easy, motor disassembly question Reply #2 – September 01, 2009, 12:14:54 PM Yea, stock HO cam. Quote Selected
quick and easy, motor disassembly question Reply #3 – September 01, 2009, 04:31:19 PM NO.You don't have to install the roller lifters in the same spot on a roller engine.you can dump it all in a box (just being extreme as an example),and re-install the parts.No worries. Quote Selected
quick and easy, motor disassembly question Reply #4 – September 02, 2009, 07:56:12 AM Thanks Vinnie. Quote Selected
quick and easy, motor disassembly question Reply #5 – September 02, 2009, 09:35:07 AM I just cut up a cardboard box for this. Make slits for each part in the respective location, then draw "FRONT" and "REAR" on the proper end of the box. Stick the parts in the slit for the box to hold, put it somewhere safe, and continue working. :) Quote Selected
quick and easy, motor disassembly question Reply #6 – September 02, 2009, 01:11:53 PM I'd try to reinstall the parts in the same position, but with a roller cam it isn't absolutely necessary... Quote Selected
quick and easy, motor disassembly question Reply #7 – September 02, 2009, 01:40:17 PM ^^^ I agree with him. Quote Selected
Topic: quick and easy, motor disassembly question (Read 776 times)
previous topic - next topic
