Skip to main content
Topic: Trans tunnel opening pics? (Read 1162 times) previous topic - next topic

Trans tunnel opening pics?

Does anyone have a pic of their trans tunnel opening with the shifter installed? I just put in my trans and I don't remember it being this far forward. py pic, I know.

Trans tunnel opening pics?

Reply #1
Mine is every bit that far forward and I have a 3/4" longer sn-95 T5.  I just have enough room to stick a socket and extension onto the front bolts.
One 88

Trans tunnel opening pics?

Reply #2
That's about the same position as my little 4 bangers T5 shifter.  Have you installed the driveshaft yet?  That may give you more assurance that it is correct.

Trans tunnel opening pics?

Reply #3
Yup, mine have always been pretty far forward as well.
Long live the 4-eyes!  - '83 Tbird Turbo - '85 Marquis LTS - '86 LTD Wagon

Trans tunnel opening pics?

Reply #4
Ok, I just wanted to be reassured. The car has been apart for so long.

The driveshaft is another issue. Anyone know the minimum amount of the yoke that needs to be engaged in the trans? This is not the stock driveshaft and it looks to be short. I will have to go out and actually measure it. At the time I was frustrated and just left it.

Trans tunnel opening pics?

Reply #5
I have to crush the rubber boot on the rear trans seal to get my shaft out.  The yoke rides right up to that boot installed.  Not sure what the minimum would be.

Trans tunnel opening pics?

Reply #6
I will have to call Swarr Auto tommorow and find out. I only have about half to three quarters of the yoke engaged.

Trans tunnel opening pics?

Reply #7
I'm pretty sure you want 3/4" - 1" of shaft left before bottoming out on the tail shaft.  I know mine is a hair too deep as I only have about 1/2" of shaft left, but my driveshaft is also flat because the car is lowered so no worries about the shaft going in further.
One 88

 

Trans tunnel opening pics?

Reply #8
I know this is with the Rubber seal on there but here is a pic. It puts the shifter about where yours is. This is in my 84 Turbo coupe.
84 Turbo coupe 2.3T Modded with 88 upper and lower intake, 88 injectors, E6 manifold, T3-4 AR.60 turbo, 31X12X3 FMIC, Homemade MBC , Greddy knock off BPV.
4 eyes see better than 2! 
Da Bird!

FreeBird