aluminum 4.6L DOHC motor October 17, 2007, 09:12:46 PM need to sell this motor to buy another one*lightly honed '95 teksid block from mark 8*turned .25mm mark 8 cast 6 bolt crank*stock mach 1 rods and pistons (under 3,000 miles)*sealed power rings*new bearings throughout(dont remember the brand)*rotating assy. balanced with stock flexplate and balancer from 95 mark 8 by Harris Engine Grinders(shortblock assembled by TSS)*new tty main cap bolts*'01 cobra heads w/ 3 angle valve job (done by Joe Halliday)*96-98 cobra cams*'99+ timing cover*'95 mark 8 water pump, pulley, chains, tensioners, and guides*01 continental cam covers and coil covers(black)w/ new spark plug grommets*t-stat housing*mark 8 coolant crossover tube*03 cobra/mach 1 exhaust manifolds and h-pipe*block separator plate*stock motor mounts*2v oil pan*new HV oil pump/pickup tube from TVF*stock 3-bolt starter*new MLS ford head gaskets and tty head bolts*stock water/oil filter housing*full set of stock lash adjusters and rockersmotor is already assembled. i have roughly $2400 into this.$2,000 OBO Quote Selected
aluminum 4.6L DOHC motor Reply #1 – October 19, 2007, 10:50:35 AM $1000 OBO for heads w/ cobra cams, sprockets, sec. tensioners, and chains$1100 for shortblock w/ stock oil pan, stock balancer, stock flexplate, and new high volume oil pump$100 cobra exhaust manifolds$60 primary chains and tensioners w/ guides$100 99+ timing cover w/ belt tensioner$150 COP cam covers w/ coil covers Quote Selected
aluminum 4.6L DOHC motor Reply #2 – October 23, 2007, 11:35:37 PM Why part it? it looks purdy!!!!!!!! Quote Selected
aluminum 4.6L DOHC motor Reply #3 – November 01, 2007, 08:54:14 PM Dang!!! Some good parts and me without the $$$$. Quote Selected
aluminum 4.6L DOHC motor Reply #4 – November 01, 2007, 09:05:39 PM its sold already, and has been replaced with a navigator motor. Quote Selected
Topic: aluminum 4.6L DOHC motor (Read 459 times)
previous topic - next topic
