New Here 83 Thunderbird Reply #30 – October 03, 2012, 10:09:27 PM Must be, he said that the rear end from a Lincoln. Quote Selected
New Here 83 Thunderbird Reply #31 – October 03, 2012, 11:08:39 PM I think you wont be able to use the wheel caps or something along those lines. Quote Selected
New Here 83 Thunderbird Reply #32 – October 04, 2012, 09:00:26 AM Dang so I should get some different rotors, what car should I get some from? Quote Selected
New Here 83 Thunderbird Reply #33 – October 04, 2012, 01:05:48 PM My buddy who had car, says ranger rotors are on there, idk Quote Selected
New Here 83 Thunderbird Reply #34 – October 04, 2012, 01:24:06 PM Since they are Ranger rotors, you'll be fine. I forgot about those . With the Lincoln rotors, there is the issue of the wheel centers not fitting. Sorry, deidn't mean to get you worried there. Quote Selected
New Here 83 Thunderbird Reply #35 – October 04, 2012, 02:07:10 PM ok good, now I have to worry with nine inch under the it, should I measure from outside of rear rotors to get correct width. Quote Selected
New Here 83 Thunderbird Reply #36 – October 04, 2012, 04:26:31 PM You could do that, then just add the measurement from the wheel mounting surface to the outside rotor surface twice for your width. Good luck and have fun :D Quote Selected
New Here 83 Thunderbird Reply #37 – October 06, 2012, 01:07:44 PM Rear end looks to be about 631/4. I am measuring from outside of rotors to outsid rotors and then adding the space in to the mounting surface. Quote Selected
New Here 83 Thunderbird Reply #38 – October 06, 2012, 01:16:32 PM I ran the brake lines over from the block to the passenger side, I used the line from the parts car, I hope I did ok on my double flaring, first time doing that. I got new hoses also and clips to hold them to bracket. Quote Selected
New Here 83 Thunderbird Reply #39 – October 08, 2012, 02:50:48 PM I mounted rack and the vacuum tee!! Quote Selected
New Here 83 Thunderbird Reply #40 – October 09, 2012, 04:04:36 PM Started the process of tucking wires, while waiting on some funds to get some other parts. I plan on using some wire loom, I just laid it out today to get idea where it will run and make sure nothing will be in the way. Quote Selected
New Here 83 Thunderbird Reply #41 – October 10, 2012, 01:52:45 PM New outter tie rod ends!! Quote Selected
New Here 83 Thunderbird Reply #42 – October 10, 2012, 05:41:36 PM Nice project. Wish I was that handy. Quote Selected
New Here 83 Thunderbird Reply #43 – October 10, 2012, 08:51:55 PM Thanks, you bird looks good!! Quote Selected
New Here 83 Thunderbird Reply #44 – October 13, 2012, 07:43:48 AM I put in a the filler neck to the gas tank from the parts car on Thursday. The one that was on the car was shot out!!! Quote Selected