turbocoupe idle March 14, 2010, 07:29:54 PM my turbocoupe idles rough when at normal temp and dies when I push in the clutch to stop need help dont wont it to get worse. Quote Selected
turbocoupe idle Reply #1 – March 14, 2010, 08:37:11 PM check for codes? i have to do the same on mine. I have a high idle no matter what when it warms up or when its cold. Ive even adjusted the idle set screw no luck. Quote Selected
turbocoupe idle Reply #2 – March 14, 2010, 09:43:55 PM also what should happen when you unplug the idle air control Quote Selected
turbocoupe idle Reply #3 – March 14, 2010, 09:47:40 PM should stall out if i remember right. But im unsure. Quote Selected
turbocoupe idle Reply #4 – March 14, 2010, 09:59:49 PM this is off my problem but why is it that the tc wont build boost siting still with spout in but with it out it builds 5psi+ siting still Quote Selected
turbocoupe idle Reply #5 – March 14, 2010, 10:34:34 PM it shouldn't build any boost just at idle. it woill start building boost at 2500 rpm as you drive. Then if your boost controller is bad or you don't have one you will only make 5 psi no matter how hard you drive it. Quote Selected
turbocoupe idle Reply #6 – March 14, 2010, 10:36:57 PM sorry i meant reving it while siting still Quote Selected
turbocoupe idle Reply #7 – March 14, 2010, 10:43:04 PM With your IAC unplugged it should idle about 800-900. You shouldn't be building anyboost while sitting still. It should only be building boost when the engine is under a load.It would make diagnosing your idle issue easier if we knew more details. Have you done a tune-up (plugs, rotor, cap, wires, fuel/air filter). Have you pulled codes (you can pull codes with a paper clip and the CHL), have you checked the volts at the tps, have you set the base idle? Quote Selected
turbocoupe idle Reply #8 – March 14, 2010, 10:45:44 PM so the iac is bad when the car dies as soon as i unplug it and that could explain all my other problems Quote Selected
turbocoupe idle Reply #9 – March 14, 2010, 10:53:09 PM Quote from: Thunderbus;314243so the iac is bad when the car dies as soon as i unplug it and that could explain all my other problemsNot necassarily...... Quote Selected
turbocoupe idle Reply #10 – March 14, 2010, 10:59:36 PM ok ill keep searching need to get i fixed so i can sell it Quote Selected
turbocoupe idle Reply #11 – March 15, 2010, 12:44:48 AM You will build boost with the spout out because the timing is way retarded then.My car doesnt stall when I unplug the IAC. It does when I unplug the TPS though.Make sure theres no vac leaks. Quote Selected
Topic: turbocoupe idle (Read 1213 times)
previous topic - next topic
