Skip to main content
Topic: Replacement fuel line (Read 720 times) previous topic - next topic

Replacement fuel line

I have a leak in my fuel line by the tank where the plastic line plugs into the metal line. anybody know if you can get the hard line that the plastic line plugs into anywhere? i dont want the whole hard line just like a short section with the correct end for the plastic line to connect to. Thanks

Replacement fuel line

Reply #1
Are you talking about the metal line on the tank itself?
Long live the 4-eyes!  - '83 Tbird Turbo - '85 Marquis LTS - '86 LTD Wagon

Replacement fuel line

Reply #2
I know we sell the replacment plastice fitting in our help section. But have you checked the O-rings inside the plastic conector? Maybe one of them is missing or dried out and cracked. I know you can find replacments to put in there. Just don't have a clue where to get the metal  line without replacing the sender unit.
84 Turbo coupe 2.3T Modded with 88 upper and lower intake, 88 injectors, E6 manifold, T3-4 AR.60 turbo, 31X12X3 FMIC, Homemade MBC , Greddy knock off BPV.
4 eyes see better than 2! 
Da Bird!

FreeBird

Replacement fuel line

Reply #3
no not the sending unit lines. where it goes from the plastic line to metal line above the rear axle near the tank. i think i found somethin at advance online this one or this one then ill just run rubber F.I. line between that and the stock line.

Replacement fuel line

Reply #4
Try classictube.com  They have the supply, return, and vapor metal lines listed for mustang.......They may be similar to our cars.  Someone else might know better.  Not cheap though

Replacement fuel line

Reply #5
Sorry man on my 84 Turbo coupe its plastic frim the rail to the inline pump then plastic to the filter then plastic all the way to the sender. I bet that is what chuck W was thinking to. If you are gonna use rubber line I tell you to get the Fuel injection fuel hose. The regular stuff isn't for high psi apps. They also have fuel injection hhose clamps that cost more and are a better design.
84 Turbo coupe 2.3T Modded with 88 upper and lower intake, 88 injectors, E6 manifold, T3-4 AR.60 turbo, 31X12X3 FMIC, Homemade MBC , Greddy knock off BPV.
4 eyes see better than 2! 
Da Bird!

FreeBird

 

Replacement fuel line

Reply #6
Use injection hose+good clamps.It will get you by.
Old Grey Cat to this.88 Cat, 5.0 HO, CW mounts, mass air, CI custom cam, afr165's, Tmoss worked cobra intake, BBK shorty's,off road h pipe, magnaflow ex. T-5,spec stage 2 clutch, 8.8 373 TC trac loc, che ajustables with bullits on the rear. 11" brakes up front. +