Speedogear for TC - How many teeth do you have? June 01, 2010, 09:21:31 AM Hi guys. I have a problem with wrong reading speedometer. You told me some time ago that I need to change my speedogear. I had a look on it and I have 17 teeth speedogear (green). I have swapped transmission from some Mustang (my father did it), so that must be the reason. I don't know what rear-end ratio that stang had. So please tell me, how many teeth speedogear I need. Here is a small help:I'm driving 90 km/h (56,25 MPH) and the speedometer shows 70 MPH.I think I need 19 or 20 teeth speedogear, but I'm not sure.PS: I have stock rear axle and a bit smaller tires (215/60R15 I think). Quote Selected
Speedogear for TC - How many teeth do you have? Reply #1 – June 01, 2010, 09:38:24 AM Each tooth added to the gear will reduce it 3-4 MPH, I'd go with the 20... Quote Selected
Speedogear for TC - How many teeth do you have? Reply #2 – June 01, 2010, 09:48:12 AM Quote from: TurboCoupe50;323917Each tooth added to the gear will reduce it 3-4 MPH, I'd go with the 20...It will reduce the reading 3-4 MPH in which speed? 30 MPH, 50 MPH, 100MPH,...? Quote Selected
Speedogear for TC - How many teeth do you have? Reply #3 – June 01, 2010, 12:39:47 PM Is this new transmission a 5 speed or an automatic?What was the original? Also, what is your axle ratio? Quote Selected
Speedogear for TC - How many teeth do you have? Reply #4 – June 01, 2010, 05:04:37 PM 60mph... Quote Selected
Speedogear for TC - How many teeth do you have? Reply #5 – June 01, 2010, 06:39:54 PM http://www.steeda.com/products/speedometer_recalibration_gears.phpIf you can figure out your axle ratio, you'll be able to buy the correct gear. Quote Selected
Speedogear for TC - How many teeth do you have? Reply #6 – June 02, 2010, 06:35:30 AM Quote from: V8Demon;323926Is this new transmission a 5 speed or an automatic?What was the original? Also, what is your axle ratio?It's C3 automatic. Original was C3 too. Rear end ratio is 3,45, as all TCs have.So, please tell me, what YOU have. I know all the links with speedogears and calculators, but I don't know one number (how many teeth have the drive shaft gear), so I can't get the result. Quote Selected
Speedogear for TC - How many teeth do you have? Reply #7 – June 02, 2010, 10:49:48 AM Unless you find someone with same combo that you have, their gear info will be useless to you... The '87-'88 automatics used a A4LD tranny and 3.73 rear gears... With a Super Coupe AOD, 225/60/16", and 3.73s I run a 21 tooth gear to be correct... The Std Fox Bird AOD & 3.73 requires 23 tooth gear(which Ford doesn't make), aftermarket suppliers sell a Chrysler gear for this application... Quote Selected
Speedogear for TC - How many teeth do you have? Reply #8 – June 02, 2010, 11:28:12 AM What's wrong with my 86? I thought that all these 4 eyed turbo coupes had C3 and 3,45 LSD. Don't worry about tires, it's only minimal difference. Quote Selected
Speedogear for TC - How many teeth do you have? Reply #9 – June 02, 2010, 11:59:29 AM Here is a speedo gear calculator that I use and it works very well.http://www.angelfire.com/mb/mustangsrule/speedogear.htmlTypically you can use a flash light and look up into where the speedo cable goes into the tranny and determine the color of the drive gear (gear on the output shaft of the tranny). Once you have this, the cirspoogeference of the rear tire (typically you can find this on your tire from http://www.tirerack.com), and the rear gear ratio you can find the closest driven gear to get the speedo correct.Darren Quote Selected
Speedogear for TC - How many teeth do you have? Reply #10 – June 02, 2010, 01:25:37 PM Quote from: Aerocoupe;324015Typically you can use a flash light and look up into where the speedo cable goes into the tranny and determine the color of the drive gear (gear on the output shaft of the tranny).While I'm not sure of the C3 trannys, most automatics have the teeth cut into the output shaft, thus it has no color, I doubt color listed for the T-5 would be correct anyway...Quote from: Trinom;324013What's wrong with my 86? I thought that all these 4 eyed turbo coupes had C3 and 3,45 LSD. Don't worry about tires, it's only minimal difference.Nothing unique about your combo, just that I don't know of any others that have a 86 TC with automatic... Quote Selected
Speedogear for TC - How many teeth do you have? Reply #11 – June 02, 2010, 06:07:00 PM I think it can be 85 or 86. I'll take a look around. In short past there have been here few new registered 85/86 TCs. Quote Selected
Speedogear for TC - How many teeth do you have? Reply #12 – June 02, 2010, 06:20:10 PM Well, my donor car was a 86 XR7 with a C3 and 3.45s. What information do you need? Quote Selected
Speedogear for TC - How many teeth do you have? Reply #13 – June 02, 2010, 06:28:45 PM Quote from: Loaded87IROC;324050Well, my donor car was a 86 XR7 with a C3 and 3.45s. What information do you need?How many teeth does your speedogear have.I've send you a message with link to this thread, but you were faster :-D Quote Selected
Speedogear for TC - How many teeth do you have? Reply #14 – June 02, 2010, 06:31:05 PM Was not aware the teeth were cut into the output shaft on the C3. Learn something new everyday!Darren Quote Selected
Topic: Speedogear for TC - How many teeth do you have? (Read 2407 times)
previous topic - next topic
Topic: Speedogear for TC - How many teeth do you have? (Read 2407 times)
previous topic - next topic