Re: Issues with remote start install - guages don't work
Reply #7 –
Uhhh.... the board must have deleted some of the words from my post. Here's the original version, with the missing words put back. :D
It gets power from the ignition switch via A12, and sends 5V to the gauges, which have their own grounds via their "senders", and to the low-fuel module via A14.
Well, while the cluster is out, check for 12v at the grey plug's A12 (grey/yellow? Eric says lightblue/pink) with the key on.
Ground should be B18 (brown plug).
You can also check the gauges themselves with a 6-9v battery.
Connect the battery across each gauge's two terminals (just for a couple of seconds). If the needle moves, the gauge is okay.