Skip to main content
Topic: Which steering rack?. (Read 1986 times) previous topic - next topic

Which steering rack?.

3.8 cougar.just had my mot and failed on excessive play in the rack looked at rock auto but don't know which is correct . one/two piece mounting bush and with/without performance suspension what am I looking for?.

Which steering rack?.

Reply #1
Year of car? Trim level?

What is the diameter of your steering rack mounting bolts? The larger ones (M16 - ish) are the 1-piece bush. The smaller ones (M12's, I think) are the 2-piece. They also have a longer sleeve that goes into the K-member, that the others do not. Either bushing type will fit in the rack.
Some folks retrofit the later (2-piece) bushing/sleeves for the 1-piece set-up. You can get poly bushings for either, but the 2-piece are more common.

Unless your car is a turbo or an XR-7, it probably doesn't have the Sport suspension. Read up HERE ON COOLCATS for more info.
Long live the 4-eyes!  - '83 Tbird Turbo - '85 Marquis LTS - '86 LTD Wagon

Which steering rack?.

Reply #2
It's an 86 just standard ,measured the mounting bolts got 12mm so 2 piece it is . going to drain and clean before refilling but can't find the amount of fluid I require to refill?.

Which steering rack?.

Reply #3
Go with the performance rack, and just fill until shes full.
88 Cougar
88 T-Bird
other cars that don't apply to this forum

Which steering rack?.

Reply #4
Ok got replacement rack already to fit came with new bushes and a pack of seals two same sized small rubber o-rings approx id 7.5mm 11.5mm od and two teflon seals different sized 11mm id 13.5 od & 13mm id 15mm od  didn't find any seals on the pipe joins when I removed only PTFE tape on the threads also Manual doesn't mention anything about seals are these needed?.

Which steering rack?.

Reply #5
The teflon seals should be used where the hoses mount to the steering rack.
88 Thunderbird LX: 306, Edelbrock Performer heads, Comp 266HR cam, Edelbrock Performer RPM intake, bunch of other stuff.

 

Which steering rack?.

Reply #6
Ok thanks also found the two small o-rings fit on the pipe under the nuts.