Skip to main content ↑ ↓
Topic: Driveshaft Yoke and rear interchangeability (Read 1153 times) previous topic - next topic

Driveshaft Yoke and rear interchangeability

I'm looking to get an aluminum driveshaft made are the Yoke and the rear  the same as the fox mustang?
88 Cougar
88 T-Bird
other cars that don't apply to this forum

Driveshaft Yoke and rear interchangeability

Reply #1 –
Yes.

However, there are multiple yokes and axle s. The aod yokes are longer and have a weight on them, the t-5's are shorter and dont, but they are fully compatible with each other.

There are a few different 8.8" axle s, but mostly they are large and small. I believe ours to be the smaller one.
Quote from: jcassity
I honestly dont think you could exceed the cost of a new car buy installing new *stock* parts everywhere in your coug our tbird. Its just plain impossible. You could revamp the entire drivetrain/engine/suspenstion and still come out ahead.
Hooligans! 
1988 Crown Vic wagon. 120K California car. Wifes grocery getter. (junked)
1987 Ford Thunderbird LX. 5.0. s.o., sn-95 t-5 and an f-150 clutch. Driven daily and going strong.
1986 cougar.
lilsammywasapunkrocker@yahoo.com

Driveshaft Yoke and rear interchangeability

Reply #2 –
Awesome would you know the length of driveshaft I would need for an aod and a 8.8?
88 Cougar
88 T-Bird
other cars that don't apply to this forum
 

Driveshaft Yoke and rear interchangeability

Reply #3 –
Quote from: Moonmount;456936
Awesome would you know the length of driveshaft I would need for an aod and a 8.8?

I dunno but I'm using one from a '87 5.0 Bird with 7.5", fits just fine...