Skip to main content ↑ ↓
Topic: Tripminder reset? (Read 1615 times) previous topic - next topic

Tripminder reset?

Installed my tripminder finally and it will only display the time and says RESET. I have tried to reset the time by the ford book, but it just doesn't do anything at all. The time keeps counting from 12:00 when I plugged it in and never changes even if I un-plug it.  Any help would be appreciated.

Tripminder reset?

Reply #1 –
Its a pain. Did you clean the buttons?
Quote from: jcassity
I honestly dont think you could exceed the cost of a new car buy installing new *stock* parts everywhere in your coug our tbird. Its just plain impossible. You could revamp the entire drivetrain/engine/suspenstion and still come out ahead.
Hooligans! 
1988 Crown Vic wagon. 120K California car. Wifes grocery getter. (junked)
1987 Ford Thunderbird LX. 5.0. s.o., sn-95 t-5 and an f-150 clutch. Driven daily and going strong.
1986 cougar.
lilsammywasapunkrocker@yahoo.com

Tripminder reset?

Reply #2 –
I didn't do anything to it.  All of the buttons move freely and click when they are pushed in. I guess that is what I will try and see what happens. thank you for the quick response. I will post my findings, Thanks

Tripminder reset?

Reply #3 –
It is pretty important to take them apart and clean the button contacts for the buttons to work.  Remember, these are 30 year old electronics and some corrosion does occur over time.  I've sold quite a few of these cleaning the buttons works most of the time on nonresponsive units.

Here is a video I made a while back for a customer verifying proper functioning and how to set the time.  (Click pic for video)

1986 Mercury Cougar - 2.3T/T5 swap, TC brakes and suspension and rearend, 3" exhaust, 255 lph fuel pump, Stinger BOV, Gillis MBC @ 18 psi
2003 Chevy Suburban Z71 - Daily driver
2015 Chevy Volt - Wife's daily driver

Tripminder reset?

Reply #4 –
Cleaned The buttons and IT WORKS!!!!  Thank you guys so very much. I have been trying to get some long awaiting upgrades done and this was one of them. I took it apart and went underneath the buttons with some very fine sand paper and all is well. Thanks again

Tripminder reset?

Reply #5 –
I wish mine was that bright like in the pic. It functions, but not that bright at all. How does it come apart for cleaning/ What do you use for cleaning?
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Tripminder reset?

Reply #6 –
2 push-in tabs on each of the two sides and it slides apart. Un-plug the bunch of wires to separate the two halves and then there are 4 small screws that remove the face from the housing. I just slid some fine sand paper under the silver plates that activate the functions when the buttons are pressed and re-assembled. You will understand it as you take it apart, just be gentle.    Next is to figure out how to  change the mileage on my 140 mph speedo so it matches the mileage on the car.
 

Tripminder reset?

Reply #7 –
The speedos I have done. Now to do my trip minder.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..