Skip to main content
Topic: bad compression (Read 2857 times) previous topic - next topic

bad compression

Reply #15
You are chasing BALLOONS running codes is a waste of time as that ECM is not that sophisticated. And fuel in the OIL is a mechanical or outside issue other than the ECM or a balance test. A balance test is used for cylinder balance not an over rich issue. Chasing Balloons is something that people do on a regular basis.
I spend money I don't have, To build  cars I don't need, To impress people I don't know

HAVE YOU DRIVEN A FORD LATELY!!

bad compression

Reply #16
unless he had a bad injector, then the balance test would have told him that. now he knows its a regulator.
Quote from: jcassity
I honestly dont think you could exceed the cost of a new car buy installing new *stock* parts everywhere in your coug our tbird. Its just plain impossible. You could revamp the entire drivetrain/engine/suspenstion and still come out ahead.
Hooligans! 
1988 Crown Vic wagon. 120K California car. Wifes grocery getter. (junked)
1987 Ford Thunderbird LX. 5.0. s.o., sn-95 t-5 and an f-150 clutch. Driven daily and going strong.
1986 cougar.
lilsammywasapunkrocker@yahoo.com

bad compression

Reply #17
If he had a bad injector the second he drove it one block he would know it!!!!
I spend money I don't have, To build  cars I don't need, To impress people I don't know

HAVE YOU DRIVEN A FORD LATELY!!

bad compression

Reply #18
on a 2.3, yes. on a 3.8 or 5.0, probably not.
Quote from: jcassity
I honestly dont think you could exceed the cost of a new car buy installing new *stock* parts everywhere in your coug our tbird. Its just plain impossible. You could revamp the entire drivetrain/engine/suspenstion and still come out ahead.
Hooligans! 
1988 Crown Vic wagon. 120K California car. Wifes grocery getter. (junked)
1987 Ford Thunderbird LX. 5.0. s.o., sn-95 t-5 and an f-150 clutch. Driven daily and going strong.
1986 cougar.
lilsammywasapunkrocker@yahoo.com

bad compression

Reply #19
i did a fuel pressure test and it was at 28psi while at idle when i disconected the vacuum line going to the fpr it increased to 38psi turbotbird.com says the fuel pressure should be at 35-45psi at idle im starting to think its an injector if i adjusted the fpr and increased the pressure i dont see how that would help keep fuel out of the oil what do you guys think it is

bad compression

Reply #20
earlier you smelled fuel inside your vac line for the fpr.

your fpr needs replaced.

why it would be a possible cure to your issue is this.......

when your injector gets its ground from the EEC, its internal shaft moves a check valve to let the "regulated amont" of fuel pass through for only the amount of time the EEC supplies the ground.

if your FPR is faulty, faulty in a way that you have too much fuel presure present at each injector, then your unburnt full that sneaked by inside the injector has to go somewhere.

thats my theory,,,,,

bad compression

Reply #21
if you have a held pump vac gauge, does the regulator hold vac pressure?

or

if you simply put a vac line on the regulator, the suck on the other end ,, and then does the hose stick to your tongue? and stay put?

if not the diaphram inside the regulator is done.

 

bad compression

Reply #22
it was the fpr threw one on from autozone and its not runnin as rich the oil pressure has gone up and no more fuel in the oil thanks for the help