83 tb 5.0 electrical questions August 09, 2013, 04:04:41 PM ignition wire on starter solenoid not getting 12v, I have it at the column (hot when in crank mode with key). I think there is a plug in between somewhere?dash lights, clock light, ash tray light, and a/c control not getting 12v at the bulb plugBlinkers not coming on when turned onAcc 12v where radio goes does not have 12vI check power spots in the fuse holder, look good on both sides of fuesI have power for low beam and high beam, tail lights, brake lights, hazards, cigarette lighter plug, and clock works.Just curious if I missing a main plug or ground somewhere?I did take out the column from the 84tb v6 car and put in for the tilt steering, plugs plugged right in. Quote Selected
83 tb 5.0 electrical questions Reply #1 – August 09, 2013, 05:19:40 PM Sounds like stuff isn't connected at the fender solenoid/junction. When converting to a PMGR starter, you still need to keep it. I wont bore you with the details of the procedure, as I'm sure you did your research. Quote Selected
83 tb 5.0 electrical questions Reply #2 – August 09, 2013, 09:23:19 PM Yea i got a diagram for that starter. Quote Selected
83 tb 5.0 electrical questions Reply #3 – August 09, 2013, 09:28:35 PM I think I see what fender plug your talking about (3rd pic), but I have a set of other plugs on the driver side that are not plugged to anything. (2nd pic)and (blue wire going for horn?)I have a slim rectangle plug over by the passenger slide that I thought went to the voltage regulator. (1st pic)Please keep in mind on the pictures, that the wire are tuck in side finders. Quote Selected
83 tb 5.0 electrical questions Reply #4 – August 09, 2013, 09:49:43 PM And I took out shifter column, not sure if there is a safety switch somewhere? Quote Selected
83 tb 5.0 electrical questions Reply #5 – August 09, 2013, 11:16:23 PM NSS Not cut threw!!! Quote Selected
83 tb 5.0 electrical questions Reply #6 – August 09, 2013, 11:55:12 PM I will try it tomorrow, thanks Quote Selected
83 tb 5.0 electrical questions Reply #7 – August 10, 2013, 02:31:58 PM update, that worked tom, thanksI took out the light switch, it was all corroded up, so I cleaned the one I had from parts car and made sure to use contact cleaner and made the spring and contacts clean. Now I have 12v from the light switch and it dims my test light. but I don't have power at the bulbs, so I jump a wire from the cigarette light constant 12v and the light works, not sure where from there.Blinkers are now workingNo 12v acc at radio Quote Selected
83 tb 5.0 electrical questions Reply #8 – August 11, 2013, 11:34:14 PM Ok got the bulbs working, and got the blower working, I am finding that the dirt dobber have caused some connection issues. Quote Selected
Topic: 83 tb 5.0 electrical questions (Read 1507 times)
previous topic - next topic
