hydraulic slave cylinder May 26, 2008, 01:35:20 PM does anyone know how the clutch slave cylinder is held to the transmission? mine was already removed so i never seen how it attached. Pics? Quote Selected
hydraulic slave cylinder Reply #1 – May 26, 2008, 05:49:09 PM Is it inside the bellhousing or outside? I just pulled the tranny out of my son's 1993 ranger 2.3 5 speed. It is inside the bellhousing. It is held on by two small bolts, about 10mm iirc. We started in the morning, had lunch and finished by supper. I went slow and explained all I could to him...he doesn't know a tie rod from a tire iron, but I have him assist me in everything from oil changes to engine rebuilds...I hope he picks up a little info...Good Luck!! Quote Selected
hydraulic slave cylinder Reply #2 – May 26, 2008, 09:29:24 PM Just slides on the side, and has a plastic cover and bolt to retain it. Quote Selected
Topic: hydraulic slave cylinder (Read 812 times)
previous topic - next topic
