another valve cover question May 30, 2007, 12:34:06 PM I'm finally getting my motor built. I have used a ported set of mustang heads, Crane rocker arm stud conversion kit (p/n. 36655-16), and Motorsport 1.6 roller rockers with ploylocs. I need a minimum of 3" of inside height in the valve covers. The stock valve covers are not high enough. I will be using an explorer intake with a 1" spacer most likely. What valve covers do you guy reccomend? I was trying to stay with the efi style if possible. Quote Selected
another valve cover question Reply #1 – May 30, 2007, 11:52:52 PM Someone makes spacers to raise the valvecovers. Check TransDapt, Canton or do a search. I used to know, need some for some "Cobra" valvecovers. If I run across the info again, I'll post it. Quote Selected
another valve cover question Reply #2 – May 31, 2007, 12:35:02 AM id use the tall FMS valve covers. usually aftermarket rockers will clear the EFI ones if you remove the baffle. those adapters cost almost as much as the the valve covers i suggetsed. you can find the black "ford racing" ones on ebay for $100. Quote Selected