Skip to main content
Topic: Spark plug wires (Read 1281 times) previous topic - next topic

Spark plug wires

I am getting ready to put new wires on. I have used Accel super stocks the last 2 sets, but am thinking of using the 9mm Ford Motorsport wires this time, anybody use the ford wires? how do they fit on an 88tbird?

Re: Spark plug wires

Reply #1
I would assume that they would fit fine.... Unless your old wires were damaged I doubt you will notice much diffrence.
Quote from: jcassity
I honestly dont think you could exceed the cost of a new car buy installing new *stock* parts everywhere in your coug our tbird. Its just plain impossible. You could revamp the entire drivetrain/engine/suspenstion and still come out ahead.
Hooligans! 
1988 Crown Vic wagon. 120K California car. Wifes grocery getter. (junked)
1987 Ford Thunderbird LX. 5.0. s.o., sn-95 t-5 and an f-150 clutch. Driven daily and going strong.
1986 cougar.
lilsammywasapunkrocker@yahoo.com

Re: Spark plug wires

Reply #2
The motorsport wires fit fine. I've used them with no problems.

Re: Spark plug wires

Reply #3
Just like 5.0willgo said....they fit fine. :)
[SIGPIC][/SIGPIC]http://www.fquick.com/slicksport88
88 Sport - 5.0HO, Mass Air, A9L, 73mm C&L meter, BBK CAI, 255 lph pump, 1.7 roller rockers,Professional Products damper, Chuck W motor mounts, BBK shorties & H-pipe, Flowmaster 40 series, 8.8 rear w/3.27's, 93 Cobra M/C, BAER 13in. drilled/slotted rotors front and back, cobra calipers, Russell braided brake lines front & back, C/C plates, 03cobra rims, 255/40/17 Nitto 555's all around

 

Re: Spark plug wires

Reply #4
I use them on my 351 thats carbed and have no probs with fit or anything else.