MN12 seat fit in fox August 01, 2005, 11:09:47 AM will seats from a mn12 fit in my 86 cougar?http://forums.tccoa.com/showthread.php?p=644813#post644813 Quote Selected
Re: MN12 seat fit in fox Reply #1 – August 01, 2005, 11:36:01 AM ive heard of it being done, but it was only hearsayi measured my dads seats (he has an 89), and they were far too wide Quote Selected
Re: MN12 seat fit in fox Reply #2 – August 01, 2005, 01:50:58 PM think i could make em fit if i squeezed em in? and i dont have a center console it is the attached one. would i need to replace that? Quote Selected
Re: MN12 seat fit in fox Reply #3 – August 01, 2005, 03:41:51 PM I've heard both on this and the old board:"I've tried it and it can't be done.""I have them in my car now."I haven't tried it myself yet, but I'd like to hear how it turns out for you. Quote Selected
Re: MN12 seat fit in fox Reply #4 – August 01, 2005, 07:15:22 PM http://www.foxtbirdcougarforums.com/showthread.php?t=1900 Quote Selected
Re: MN12 seat fit in fox Reply #5 – August 01, 2005, 07:57:58 PM so willthe one i posted the link of fit? Quote Selected
Re: MN12 seat fit in fox Reply #6 – August 03, 2005, 12:06:18 PM I Already fitted 93 seats in a 87 Cougar once....They are not perfect fit but they will.... The back fixation is the same width and lengt (Same bolt patern) BUT The floor is different at this point. The front screw hole are at the right place but there is and angle on both front 93 seat fixation while the fox only have an angle on the console side.Also dont forget that the seats control are on the the seats..... not the console.... (As you can notice on the link you gave....)Sorry for the bad drawing... :DThis represent the side view of the seats lower frame the screw on flooor Quote Selected
Re: MN12 seat fit in fox Reply #7 – August 03, 2005, 12:08:45 PM So SLY did you just bend the 93 seat bracket to get it to fit? Quote Selected
Re: MN12 seat fit in fox Reply #8 – August 03, 2005, 12:13:39 PM No i didnt... I used Longer screw and had to adjust the hole with a file because of the angle...It's not a piece of cake, but easier than it look like...Dont forget also to remove the Seat belt clip and replace it with your Actual one.... Or it wont work.You'll turn mad if you finish installing em and realised that... (Dont ask how i know...) :giggle: Quote Selected
Re: MN12 seat fit in fox Reply #9 – August 05, 2005, 09:19:03 AM Wouldn't it be easer to unbolt the seat from the track and put the MN-12 seat on the Fox track? Just curious... Quote Selected
Re: MN12 seat fit in fox Reply #10 – August 05, 2005, 11:31:20 AM Unfortunately, The molding w/ all the switches wont fit on the old track... Quote Selected
Topic: MN12 seat fit in fox (Read 1581 times)
previous topic - next topic
