Anybody here know to convert distributor wiring to use coil packs?

Topic: Anybody here know to convert distributor wiring to use coil packs? (Read 774 times) previous topic - next topic

Anybody here know to convert distributor wiring to use coil packs?

November 05, 2011, 03:03:38 PM

Got a '88 mustang 2.3 with a bad head and picked up a '92 motor with trans for cheap. Heard it can be done, but can't find any info. Thanks guys!

Anybody here know to convert distributor wiring to use coil packs?

Reply #1 – November 06, 2011, 09:03:59 AM

Dunno, You may need the PCM and/or wiring harness for the later Stang...

I'd just use the '88 dist in the newer engine and not connect the intake side spark plugs...

Anybody here know to convert distributor wiring to use coil packs?

Reply #2 – November 06, 2011, 02:05:17 PM

I have the computer, wiring, air box, MAF sensor, and IRCM, but it's not a direct "plug-in". Distributor can't be used because the intake manifold is too large, and single plug intake has a different bolt pattern and ports to use on the dual plug head.

Anybody here know to convert distributor wiring to use coil packs?

Reply #3 – November 06, 2011, 04:57:32 PM

Quote from: 32VFoxBird;372145

I have the computer, wiring, air box, MAF sensor, and IRCM, but it's not a direct "plug-in".

Then you need to compare the '88 & '92 wiring diagrams and determine how to hook it up... If you aren't good with wiring, can't find instructions, or have a buddy that can wire it up, then you're stuck...