Skip to main content ↑ ↓
Topic: Belt Moulding (Read 1899 times) previous topic - next topic

Belt Moulding

Does anybody know were I can get Belt Moulding for my '86 T-Bird. The belt moulding is the felt moulding that keeps water from going into the door when it rains, for people who don't know. I need a new set for my car.

Re: Belt Moulding

Reply #1 –
Sorry,I don't know.They'll be the same as an '88.Go to a salvage yard with a cordless drill and some bits,find a good set from another car,drill out the rivets and there you go.Is the rubber moulding (seal) good?
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Re: Belt Moulding

Reply #2 –
well, its not produced any more, so your best bet is trying to find someone parting out a similar car or a junkyard
It's Gumby's fault.

Re: Belt Moulding

Reply #3 –
Quote from: vinnietbird
Is the rubber moulding (seal) good?


Help me out here, what seal are you talking about.
 

Re: Belt Moulding

Reply #4 –
The hollow rubber gasket that runs around the perimeter of the door jamb.The door seals up against it when you close the door.Usually,they're torn near the bottom where you put your feet in and out.Mine was like that until I bought this Mark VII and did a little seal swapping.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..