Skip to main content
Topic: Bumper installed pics! (Read 2480 times) previous topic - next topic

Bumper installed pics!

Reply #15
I actually did raise them about a half inch from where they originally were...because when I installed the bumper cover the lights were pushed against the bottom. Now they just barely clear it and I have a little room to adjust them, so it works.

Garrett H.
'94 F250 XLT- 4x4, 5 speed, 7.3 IDI Turbo Diesel, 4" intake, 4" exhaust, 5" turnout stacks, manual hubs, etc.
'87 Thunderbird Turbo Coupe
Engine, wheels, tires, etc!
Exhaust sound clip
Another clip

Bumper installed pics!

Reply #16
Driving lights rock.  Best lighting upgrade over stock fog lights. I wonder if my Hella FF75's could support higher wattage bulbs. Theyre 55W.
93 Festiva L, 193k miles, BP+T/G25MR swap, T3 50trim .48/.42, SRT FMIC, Capri electronics/Rocketchip, 2.5" exhaust
bests: ET 12.86, MPH 110.25, 1.92 short
02 Subaru Impreza WRX, 129k miles
97 Subaru Impreza Outback Sport, 236k miles

Bumper installed pics!

Reply #17
Yeah the stock fog lights suck IMO, I had mine wired for the 100W bulbs and they still didn't throw any useable amount of light.

BTW if the lights you have are aftermarket I'm sure they could run 100W bulbs. As-purchased, these ones I had came with 55W "super white" bulbs (which I hate). I found the "yellow" (actually dichroic) ones that are in there now on ebay, bought them assuming that they were 55W but they turned out to be 100W. I didn't change anything with the wiring, the 100W bulbs have the same size power wire running to them as the 55's. I have em running through a relay anyway so I wasn't too worried about it.

Garrett H.
'94 F250 XLT- 4x4, 5 speed, 7.3 IDI Turbo Diesel, 4" intake, 4" exhaust, 5" turnout stacks, manual hubs, etc.
'87 Thunderbird Turbo Coupe
Engine, wheels, tires, etc!
Exhaust sound clip
Another clip

Bumper installed pics!

Reply #18
that looks pretty freakin' sweet.
:cougarsmily:5.0 HO, E303 cam, Exploder/Cobra intake, smog pump delete, Ford Taurus electric fan, MAF conversion, BBK headers, MAC 2.5" off-road exhaust w/x-pipe, AOD w/shift kit, 8.8 Trac-Loc rear w/disc brakes, 5-lug conversion w/'98 Mustang GT 17" wheels, Mach 1 springs:cougarsmily:

 

Bumper installed pics!

Reply #19
way too COOOOL!!!!!!!!!!!!!!!!!!!
88 sport,TW heads, comp xe270hr, cobra u/Tmoss ported lower, 65 mm throttle body, under drives,smog delete,
1.7 roller rockers, cai, k&n, bbk adj regulator, 76mm Pro-m,all MSD ign. MSD dist,18° base timing, 3g alt.1 5/8 ceramic headers, 255lph walbro, 2.5" h-pipe, flowmasters, silverfox valvebody, 3.73 gear,
http://i216.photobucket.com/albums/cc154/flipnbird/DSCF0185.jpg ( RIP : ( )