Skip to main content ↑ ↓
Topic: e6se vs horsepower (Read 4259 times) previous topic - next topic

e6se vs horsepower

Has anyone built a reliable street engine using stock,ported e6se heads? How much horsepower can be produced with these heads?

e6se vs horsepower

Reply #1 –
Better to just get a set of cheap e7's,they can usually be picked up for under 100bucks and can be ported quite a bit and can flow fairly decent, but after all the port work has been done the cost factor is almost a set of used aluminums.

e6se vs horsepower

Reply #2 –
think it was this forum that i saw that e6 heads ported and with bigger valves only flow close to stock e7s. i know the e6, is a high swirl newer disign head for emmissions. i wouldnt bother with them eather, hell like most of the other stuff we up grade to with our cars, other people throw away, so you can get it very cheap. think i even have one or 2 sets of e7 heads id sell cheap just to get  rid of them.

e6se vs horsepower

Reply #3 –
e6 are a poor flowing head with  extremely shrouded valves. the valves are also sunk deeper into the heads. Good for emmisions bad for performance.

Look at the GT40 and GT40 p heads,65-66 289 heads ,69-71 351W 4 brl heads, and e7's for cheap bolt on power.
[SIGPIC][/SIGPIC]
1974 maverick lsx powered turbo car SOLD
1973 maverick Tijuana Taxi Tribute
1957 chevy LSX Turbo project (race car)
Owner of Joe Dirt Fabrication

e6se vs horsepower

Reply #4 –
sleeper t-bird 87, your bird is really cool looking, i like the airfilter coming out of the hood, it makes it look mean. i thought you couldnt have heads from the 60's because of emmisions reasons. do they flow pretty good?
1988 LX coupe. a dressed up motor with full exhaust and BBK shorties with flowmasters, BBK CAI, accufab 65mm tb, HO upper intake, cobra valve covers.

e6se vs horsepower

Reply #5 –
ok so sleeper, can i have these heads on my block? its on ebay 180025195896
1988 LX coupe. a dressed up motor with full exhaust and BBK shorties with flowmasters, BBK CAI, accufab 65mm tb, HO upper intake, cobra valve covers.

e6se vs horsepower

Reply #6 –
Quote
ok so sleeper, can i have these heads on my block? its on ebay 180025195896




These 351c heads ?! I would think they would have to be either 289/302/351w only

Why don't you just stick to whats works and thats E7's, gt40 or gt-40p or aftermarket..
[SIGPIC][/SIGPIC]

 

e6se vs horsepower

Reply #7 –
My 'Bird really runs strong,and I have E-6 heads ('86 5.0 H.O. with a few mods),but I have a set of ported E-7 heads and that should make a difference that I can feel when I hit the gas.The E-6 heads really do suck.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..