Print Page - I need a favor

Title: I need a favor
Post by: SLEEPER T-BIRD 87 on November 12, 2006, 01:27:58 AM

any of you got a 87-88 T/C rear out of a car? i need a few measurements

rotor hat to rotor hat

and backing plate to backing plate.

if anyone could get me thses id appreciate it greatly.

Title: I need a favor
Post by: Thunder Chicken on November 12, 2006, 10:20:14 PM

I've got a TC rear sitting on jackstands in the garage. I'll try to get the measurement tomorrow. If I don't, remind me (I have a tendency to forget things like this)

Title: I need a favor
Post by: SLEEPER T-BIRD 87 on November 12, 2006, 10:22:31 PM

Quote from: Thunder Chicken;113137

I've got a TC rear sitting on jackstands in the garage. I'll try to get the measurement tomorrow. If I don't, remind me (I have a tendency to forget things like this)

ok man thanks a ton

Title: I need a favor
Post by: CougarSE on November 13, 2006, 01:59:18 AM

Thinking of throwing one under the ranger? You could always use an explorer axle. 8.8 disks and 5 lug to boot.

Title: I need a favor
Post by: SLEEPER T-BIRD 87 on November 13, 2006, 08:17:19 AM

Quote from: CougarSE;113203

Thinking of throwing one under the ranger? You could always use an explorer axle. 8.8 disks and 5 lug to boot.

Possibly,Only reason i even considered it was i already have it. and the rear is already 5 lug

Title: I need a favor
Post by: Thunder Chicken on November 13, 2006, 10:57:41 AM

The measurements are:

Backing plate to backing plate: 55"
to (counting thickness of rotor as it's currently mounted on the ): 61"
Back of rotor to back of rotor: 56-3/4"

These measurements are all +/- 1/4" or so - it was difficult trying to get the measurements by myself as I had nobody to hold the other ned of the tape

Title: I need a favor
Post by: SLEEPER T-BIRD 87 on November 13, 2006, 02:44:05 PM

Quote from: Thunder Chicken;113243

The measurements are:

Backing plate to backing plate: 55"
to (counting thickness of rotor as it's currently mounted on the ): 61"
Back of rotor to back of rotor: 56-3/4"

These measurements are all +/- 1/4" or so - it was difficult trying to get the measurements by myself as I had nobody to hold the other ned of the tape

Thanks hopefully i can apply this in a usefull way ;)

Fox T-Bird/Cougar Forums

General => Lounge => Topic started by: SLEEPER T-BIRD 87 on November 12, 2006, 01:27:58 AM