Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - turbochicken87

1
Electrical Tech / Re: No Brake Lights
Quote from: mcb82gt – on
Check the brake light switch under the dash connected to the brake pedal.  My wire was corroded and not connected well.
I'll dig into it more, but when I tested the outside contacts for continuity and it seemed to be fine. It just puzzles me how there are no hazards (4 way flashers). I'd think if the brake switch was bad it would only affect brake lights, right?
Quote from: Haystack – on
Power to the brake lights run thru the multi function switch (turn signal)
I'll look for a replacement if nothing else is the issue. It controls hazards too right?
2
Electrical Tech / No Brake Lights
I have a 1987 Turbo Coupe. I was out driving and noticed my right hand turn signal was acting funky. I found the bulb that wasn't working and jiggled the wires on it. That fixed the turn signals and they operate just fine, so do the rest of the tail lamps.
However, I have no hazard lights or brake lights. Fuses 4 and 15 are intact and the switch has continuity. Would a bad flasher relay cause the brake lights to no longer function?
Any ideas are appreciated, thank you.