Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - Turbot79

2
Body/Appearance/Interior / Pillar revision
posted 06-20-2012 02:58 PM molestedmolestedmolested molestedmolested molestedmolested molestedmolested molested molested molestedmolested molestedmolested
Here is my second attempt at a pillar pod
http://i305.photobucket.com/albums/nn209/TurboT79/d0f063b2.jpg
http://i305.photobucket.com/albums/nn209/TurboT79/29bff1c1.jpg

All colored and done.
The first one is for sale if anyone wants it. How does 65$ sound plus the ride
http://i305.photobucket.com/albums/nn209/TurboT79/38832ac9.jpg
It is colored sandalwood but the finish is far from perfect.
I will also be making these on a as ordered basis if anyone is interested
Thanks
Tim
6
Body/Appearance/Interior / Pillar gauge pod
I just built a two gauge pod and it turned out really nice.  Im going to do a second one with a different pod to see if I can get the fit a little tighter and make it look a bit more factory    What do u think

Ok gotta figure out how to add a pic first
7
Body/Appearance/Interior / Cupholder?
Go to an auto body supply house and get a flexible plastic parts filler.  It is usually a two part and takes a little practice but it is both sand able and paintable.  Might just be the ticket for you
8
Misc Tech / Fuel pump access panel
I used a air chisel and cut the very top off without moving the tank then had a cutout from another car with the rounded edge and it sits nicely on top.  The only spot that was close to the lines was at the front of the point of the hump in the floor.  It took me five minutes to do
9
Electrical Tech / Adding keyless entry
Yes adding factory setup from donor car with doors  My car is a option delete car so I'm adding the illumination as well  Where can I find the evtm for this
Banks
Tim