Mirror Mirror on the door, f'n! Move!!
Reply #7 –
Additional:
Get/make a couple of little jumpers; some wire with alligator clips will do.
Unplug the harness from the switch, and make sure you have 12v at LightGreen/Yellow and a nice ground at Black.
(Or run some reeeeeeally long jumpers out to the battery.)
Clip one jumper to the LightGreen/Yellow (that lonely pin at the bottom right), and another to the Black (top left).
To make the motors spin one way, clip the other end of the power jumper to the "common" Yellows (bottom left pin), and touch the ground jumper to each of the other pins.
Red and Blue control the driver's side, Purple and DarkGreen are passenger side.
To spin the motors the other way, clip the ground jumper to the Yellows, and touch the power jumper to the other pins.
If you get motion in both directions on all pins, the wiring and motors are fine, and the switch is buggered (all of them).
.