Print Page - Can't communicate with scanner after swap

Title: Can't communicate with scanner after swap
Post by: WilkBoy on May 04, 2005, 11:19:50 PM

Hi!

I did the HO conversion on my 88 cougar. I installed a computer from an 89 mustang, and converted my stock wiring harness for mass air. The engine seems to run great, but when I accelerate, my check engine light flashes on. I think it's a problem with my O2's but I can't seem to connect to the computer with a scanner to see what codes are coming up. Is there any other modifications I need to do to the wiring harness? I'm using a computer with part# E9ZF-12A650-C2A, catch code A9P. I read somewhere that it may be because I need to modify the wiring harness for the O2 sensors? Has anyone encountered this?

Thanks,
Chris

Title: Re: Can't communicate with scanner after swap
Post by: TurboCoupe50 on May 04, 2005, 11:47:08 PM

Does the check engine light flash the codes when you activate the scanner??? If so remove the bulb, and the scanner should be able to get a large enough pulse to read codes...

Title: Re: Can't communicate with scanner after swap
Post by: WilkBoy on May 05, 2005, 11:08:00 PM

I'll have to take a look... thanks for the suggestion.

Fox T-Bird/Cougar Forums

Technical => Engine Swapping => Topic started by: WilkBoy on May 04, 2005, 11:19:50 PM