fuel cell mounting September 23, 2006, 08:50:51 PM how do you get it to sit flat in the trunk when there is a big hump in the floor?i bought a 12 gal Jaz plastic fuel cell with a 2" rear sump. if that helps. Quote Selected
fuel cell mounting Reply #1 – September 23, 2006, 09:17:40 PM cut out the floor and weld in a flat piece or shim up the low sides Quote Selected
fuel cell mounting Reply #2 – September 24, 2006, 12:26:53 AM Quote from: tbirdscott;105343cut out the floor and weld in a flat piece or shim up the low sidesive thought of that, but..... shimming one side would not allow the fittings to go underneath the floor for the sump. and cutting out the "hump" would lose the rigidity of the floor. or would this not affect it? Quote Selected
fuel cell mounting Reply #3 – September 24, 2006, 02:45:48 PM Quote from: 5ohbird;105363cutting out the "hump" would lose the rigidity of the floor. or would this not affect it?If you weld in a flat piece you shouldnt loose much, get it bead rolled or tack on a couple strips of 1/4" angle iron if you are worrried Quote Selected
Topic: fuel cell mounting (Read 856 times)
previous topic - next topic
